L shaped curve type home office desk1/23/2024 If you can make a standing leg (panel), along the mitered line with a plate on top, both sides of the plate will screw into each side of the "L". You can cover what shows from the front by just adding a wood edge to the front that would be at least 1.5". This will also keep the top edges flush, providing both sheets are the same thickness (check them first.don't assume). Overlap the joint (6" - 12"), enough to get a few rows of screws on each side. Make a support piece of 3/4" ply that runs from one sheet to the other over the joint on the bottom. Usually (but not always) a shorter joint is better (but maybe not visually). If a miter would look better to you than a cut across one of the tops at 90 degrees, that joint will be longer (the mitered one) than a 90 degree cut. Doing this with sheet stock for the top, you could just put marks where the two sheets intersect at the front, and then on each sheet draw a line to the outside corner for the miter line. Then line up the two on the back corner and see what's up front. For this project, cut your two pieces of paper 4" by 5" (using a scale of 1" = 1 foot). You could just do this with pieces of paper cut to scale. Simply, if you lap over a 4' onto a 5', you are left with 12". The only reason to know the short dimension is to figure out how much room there would be. You don't need fancy math to figure this out.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |